Journal of the European Optical Society - Rapid publications, Vol 7 (2012)
Advanced matrix laser lithography for fabrication of photonic micro-structures
Abstract
© The Authors. All rights reserved. [DOI: 10.2971/jeos.2012.12043]
Citation Details
Cite this article
References
R. F. Pease, and S. Y. Chou, "Lithography and other patterning techniques for future electronics," Proc. IEEE 96, 248-270 (2008).
D. P. Sanders, "Advances in patterning materials for 193 nm immersion lithography," Chem. Rev. 110, 321-360 (2010).
C. Wagner, and N. Harned, "EUV lithography: Lithography gets extreme," Nat.Photon. 4, 24-26 (2010).
S. D. Gittard, and R. J. Narayan, "Laser direct writing of micro- and nano-scale medical devices," Expert Rev. Med. Devic. 7(3), 343-356 (2010).
A. Ovsianikov, A. Ostendorf, and B. N. Chichkov, "Threedimensional photofabrication with femtosecond lasers for applications in photonics and biomedicine," Appl. Surf. Sci. 253, 6599-6602 (2007).
A. Ovsianikov, M. Malinauskas, S. Schlie, B. Chichkov, S. Gittard, R. Narayan, M. Löbler, K. Sternberg, K. P. Schmitz, and A. Haverich, "Three-dimensional laser micro- and nano-structuring of acrylated poly(ethylene glycol) materials and evaluation of their cytoxicity for tissue engineering applications," Acta Biomater. 7(3), 947-974 (2011).
D. Radtke, and U. D. Zeitner, "Laser-lithography on non-planar surfaces," Opt. Express 15(3), 1167-1174 (2007).
G. Subramania, Y. J. Lee, A. J. Fischer, and D. D. Koleske, "Log- Pile TiO2 Photonic Crystal for Light Control at Near-UV and Visible Wavelengths," Adv. Mater. 22, 487-491 (2010).
J. K. Gansel, M. Thiel, M. S. Rill, M. Decker, K. Bade, V. Saile, G. von Freymann, S. Linden, and M. Wegener, "Gold helix photonic metamaterial as broadband circular polarizer," Science 325, 1513-1515 (2009).
M. S. Rill, C. Plet M. Thiel, I. Staude, G. Von Freymann, S. Linden, and M. Wegener, "Photonic metamaterials by direct laser writing and silver chemical vapour deposition," Nat. Mater. 7, 543-546 (2008).
C. W. J. Berendsen, M. Škeren, D. Najdek, and F. Cerný, "Superhydrophobic surface structures in thermoplastic polymers by interference lithography and thermal imprinting," App. Surf. Sci. 255(23), 9305-9310 (2009).
M. Altissimo, "E-beam lithography for micro/nanofabrication," Biomicrofluidics 4, 3-6 (2010).
R. Menon, A. Patel, D. Gill, and H. I. Smith, "Maskless Lithography," Mater. Today 8, 26-33 (2005).
M. Campbell, D. N. Sharp, M. T. Harrison, R. G. Denning, and A. J. Turber, "Fabrication of photonic crystals for the visible spectrum by holographic lithography," Nature 404, 53-56 (2000).
W. J. Daukscher, D. Mancini, K. Nordquist, D. J. Resnick, P. Hudek, D. Beyer, T. R. Groves, and O. Fortagne, "Fabrication of Step-andflash Imprint Lithography Templates using a Variable Shaped Beam Exposure Tool," Microelectron. Eng. 75(4), 345-351 (2004).
V. Mizeikis, V. Purlys, D. Paipulas, L. Maigyte, and K. Staliunas, "Tailoring of photonic structures by femtosecond laser lithography," Proc. SPIE 8204, 820417 (2011)
M. Thiel, J. Fischer, G. von Freymann, and M. Wegener, "Direct laser writing of three-dimensional submicron structures using a continuous-wave laser at 532 nm," Appl. Phys. Lett. 97, 221102 (2010).
T. Wang, W. Yu, D. Zhang, C. Li, H. Zhang, W. Xu, Z. Xu, H. Liu, Q. Sun, and Z. Lu, "Lithographic fabrication of diffractive optical elements in hybrid sol-gel glass on 3-D curved surfaces," Opt. Express 18, 25102-25107 (2010).
S. K. Selvaraja, P. Jaenen, W.Bogaerts, D. Van Thourhout, P. Dumon, and R. Baets, "Fabrication of Photonic Wire and Crystal Circuits in Silicon-on-Insulator Using 193nm Optical Lithography," J. Lightwave Technol. 0, 1-8 (2009).
A. G. Poleshchuk, A. A. Kutanov, V. P. Bessmeltsev, V. P. Korolkov, R. V. Shimanskii, A. I. Malyshev, A. E. Matochkin, N. V. Goloshevskii, K. V. Makarov, and V. P. Makarov, "Microstructuring of optical surfaces: Technology and device for direct laser writing of diffractive structures," Optoel. Instr. Data Proces. 6(2), 171-180 (2010).
A. Bulanovs, E. Tamanis, and I. Mihailova, "Holographic recording device based on LCoS spatial light modulator," Latvian Journal of Phys. and Tech. Sciences 48(5), 60-68 (2011).
M. Tang, Z. C. Chen, Z. Q. Huang, Y. S. Choo, and M. H. Hong, "Maskless multiple-beam laser lithography for large area nanostructure/ microstructure fabrication," Appl. Opt. 50(35), 6536-6542 (2011).
K. Obata, J. Koch, U. Hinze, and B. N. Chichkov, "Multi-focus twophoton polymerization technique based on individually controlled phase modulation," Opt. Express 18(16), 17193-17200 (2010).
S. D. Gittard, A. Nguyen, K. Obata, A. Koroleva, R. J. Narayan, and B. N. Chichkov, "Fabrication of microscale medical devices by twophoton polymerization with multiple foci via a spatial light modulator," Biomed. Opt. Express 2(11), 3167-3178 (2011).
T. Sandstrom, P. Askebjer, J. Sallander, R. Zerne, and A. Karawajczyk, "Pattern generation with SLM imaging," Proc. SPIE 4562, 38-44, (2002).
L. H. Erdmann, A. Deparnay, F. Wirth, and R. Brunner, "MEMSbased lithography for the fabrication of micro-optical components," Proc. SPIE 5347, 79 (2004).
L. Erdmann, A. Deparnay, G. Maschke, M. Langle, and R. Brunner, "MOEMS-based lithography for the fabrication of micro-optical components," J. Microlith. Microfab. 4, 041601 (2005).
X. Zhu, Y. Xu, and S.Yang, "Distortion of 3D SU8 Photonic Structures Fabricated by Four-beam Holographic Lithography with Umbrella Configuration," Opt. Express 15(25), 16546-16560, (2007).
I. Divliansky, and T. S. Mayer, "Fabrication of three-dimensional polymer photonic crystal structures using single diffraction element interference lithography," Appl. Phys. Lett. 82(11), 1667-1669 (2003).
D. Pizzanelli, "The development of direct-write digital holography," Technical review at holographer.org (2004).