Journal of the European Optical Society - Rapid publications, Vol 2 (2007)

Visualization of paper structure by optical coherence tomography: Monte Carlo simulations and experimental study

Mikhail Yu Kirillin, Erkki Alarousu, Tapio Fabritius, Risto Myllylä, Alexander V. Priezzhev

Abstract


This paper analyzes the capability of an optical coherence tomography (OCT) setup to visualize paper structure by comparing experimental and Monte Carlo (MC) simulated OCT images. In the experiments, we used an OCT setup at 910 nm with the coherence length of an SLD source of 7.5 mum. Several different refractive index matching agents were applied to paper samples to enhance the visualization of their inner structure. The obtained OCT images show improved contrast in inner structure and enhanced visualization depth. A set of corresponding simulations were then performed using a previously developed MC code. A multilayer paper sheet model with non-planar fiber-air interfaces was developed to characterize the paper samples. MC simulations were carried out to study the effect of the setup parameters on the obtained OCT images. A comparison with the experimental data shows that the developed model provides a satisfactory correspondence between simulated and experimental images.

© The Authors. All rights reserved. [DOI: 10.2971/jeos.2007.07031]

Full Text: PDF

Citation Details


Cite this article

References


K. Niskanen, Paper Physics, Papermaking Science and Technology, vol. 16 (Fapet Oy, Jyvaskyla, 1998).

J. Borch et al., Handbook of Physical Testing of Paper, vol. 2 (Marcel Dekker, New York, 2002).

VTT Automation and Helsinki University of Technology, "Knowpap - e-Learning Environment for Papermaking and Automation", http://www.knowpap.com.

B. Bouma and G. Tearney (eds.), Handbook of Optical Coherence Tomography (Marcel Dekker, New York, 2002).

T. Fabritius, E. Alarousu, T. Prykari, J. Hast, and R. Myllyla, "Characterization of optically cleared paper by optical coherence tomography" Quantum Electron. 36, 181-187 (2006).

E. Alarousu, L. Krehut, T. Prykari, and R. Myllyla, "Study on the use of optical coherence tomography in measurements of paper properties" Meas. Sci. Technol. 16, 1131-1137 (2005).

M. Kirillin, A. Priezzhev, J. Hast, and R. Myllyla, "Monte Carlo simulation of optical clearing of paper in optical coherence tomography" Quantum Electron. 36, 174-180 (2006).

K. Green, L. Lamberg, and K. Lumme, "Stochastic modelling of paper structure and Monte Carlo simulation of light scattering" Appl.Optics 39, 4669-4683 (2000).

M. Mischenko, L.Travis, and A. Lacis, Multiple Scattering of Light by Particles (Cambridge University Press, Cambridge, 2006).

V. Tuchin, Optical Clearing of Tissues and Blood (SPIE Press, Bellingham, Wash., 2006).

V. Tuchin, "Optical clearing of tissues and blood using the immersion method" J. Phys. D: Appl. Phys. 38, 2497-2518 (2005).

K. Bestem'yanov, V. Gordienko, A. Ivanov, A. Konovalov, and A. Podshivalov, "Optical heterodyning study of the propagation dynamics of IR femtosecond laser pulses in a strongly scattering porous medium" Quantum Electron. 34, 666-668 (2004).

J. Saarela and R. Myllyla, "Changes in the time-of-flight of a laser pulse during paper compression" J. Pulp Pap. Sci. 29, 224-227 (2003).

J. Saarela, M. Tormanen, and R. Myllyla, "Measuring pulp consistency and fines content with a streak camera" Meas. Sci. Technol. 14, 1801-1806 (2003).

J. Silvy, "The paper and its unsuspected dimensions", Materials Science Forum 455-456, 781-786 (2004).

J. Carlsson et al., "Time resolved studies of light propagation in paper" Appl.Optics 34, 1528-1535 (1995).